500 Wing Cross Sections
Apr 15/66 Figure 2 57-00
Page 3
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.
MAIN FRAME - DESCRIPTION AND OPERATION
1. General
A. The main frame consists of the left and right wing boxes, and the center wing box. The left and right wing boxes are attached to the center wing box at the four corners where the spars and the wing root ribs meet by means of three-flanged terminal fittings and longitudinal upper and lower flanged chords at left and right buttock lines 70.85. At any one corner the center wing box spar, the wing box spar and the wing root rib are attached to the flanges of the terminal fitting.
B. The wing, as a single unit consisting of the left and right wing boxes and the center wing box is attached to the fuselage frames at body stations 540 and 664 in such a manner that the center wing box front and rear spars combine with the bulkheads at body stations 540 and 664. Another wing-to-fuselage connection is by means of the longitudinal upper flanged chords at left and right buttock lines 70.85. The center wing box skin, the wing box skin, the wing root rib and the fuselage skin attach to these flanged chords on both sides of the airplane. (See figure 1.) Other points of attachment are the main landing gear support beams, the keel beam and the longitudinal floor beams above the center wing box.
C. The primary structure of the wing is the structural components of the main frame. All other wing structures, such as leading edge, trailing edge, control surfaces and wing tips are auxiliary.
2. Wing Boxes
A. Important components of the structure of each wing box are the front and rear spars, the ribs, the upper and lower skins, and their reinforcing stringers. (See figure 2.)
3. Center Wing Box
A. The structure of the center wing box consists of front and rear spars, two spanwise beams, upper and lower skin panels, and reinforcing stringers.
500
May 15/67 BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details. 57-10-0 Page 1
Wing to Fuselage Attachment 500
57-10-0 Figure 1 Apr 15/66
Page 2
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.
500 Wing Inspar Structure
Apr 15/66 Figure 2 57-10-0
Page 3
BOEING PROPRIETARY - Copyright . - Unpublished Work - See title page for details.
WING SPARS - DESCRIPTION AND OPERATION
1. General
A. The front and rear wing spars on the left and right wing boxes are primary structural components of the main frame. They extend from the wing root rib to the wing tip. Engine support fittings, hinge supports, transmission assemblies, actuators and gearbox mounts associated with the flight controls are attached to the spars. See Flight Controls, Chapter 27, and Power Plant, Chapter 71.
B. The inboard ends of the wing spars are points of attachment of the wing boxes to the center wing box. The three-flanged fitting described in 57-41-0 is the means of attachment.
C. A main feature of the rear spar is the forged fitting to which the main gear landing beam attaches. The integral fuel tanks providing the major portion of the fuel supply storage capacity are located between the wing front and rear spars.
2. Wing Front Spars
A. The left and right front spars consist of vertical webs tapering down in depth towards the wing tips, and provided with tee-section chords along their upper and lower edges. Vertical stiffeners are attached to the forward face of each spar web. The inboard ends of the left and right front spars are attached to the front spar of the center wing box and the wing root ribs by means of a three-flanged terminal fitting.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737 AMM 飛機維護手冊 機翼 WINGS(3)
