- if yes, no further action is required.
(5) Do an inspection of the engine for Foreign Object Damage (FOD or bird strike) (Ref. AMM TASK 72-00-00-200-006).
(6) Check if an EGT deterioration greater than 62 deg. C (using EGT value recorded in the take off report) is consistant with the EGT trend monitoring data (GEM or ADEPT):
- if no, do trouble shooting of the EGT system (Ref. TASK 77-00-00-810-849)
- if yes, the engine must be replaced within five (5) cycles (Ref. AMM TASK 71-00-00-000-042) and (Ref. AMM TASK 71-00-00-400-042).
F 『 EEFF : ALL E ∞∞72-00-00∞∞∞∞∞∞∞∞∞∞Page 222
E E May 01/02 ERE
ECES E
F 『
E C F M E
E E
E 56 E
E E
TASK 72-00-00-810-812
EGT near the HPC Operating Line Limit on Engine 1
1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
77-00-00-810-849 EGT Overlimit on Engine 1 or 2 77-00-00-810-854 Loss of the EGT Indication on Engine 1 or 2 77-20-00-810-830 The EGT indication fluctuates while other parameters
are stable AMM 72-00-00-200-006 Inspection/Check of Foreign Objet Damage (FOD) (Bird Strike Included) AMM 75-31-00-210-002 Visual Inspection of the Variable Bleed Valve System
3. Fault Confirmation
__________________
A. Get the engine take off EGT data, with the use of the MCDU or DAR/QAR data.
4. Fault Isolation
_______________
A. Do this trouble shooting if the SB CFMI 72-182 has not been incorporated. If POST SB CFMI 72-182, fault message must be ignored.
(1) Check for the presence of the following CFDS messages in the Post Flight Report (PFR) and do trouble shooting as required.
- VBV ACT, HMU
- T495 SNSR, J13, ECU
- CHECK HOT AIR LEAKS ENG1
- HPTCC VLV (POS), HMU
- BSV, HMU
(2) Do a visual inspection of all the VBV doors actuators and flexible shafts through the fan duct panels. Check for offset of position between all VBV doors (Ref. AMM TASK 75-31-00-210-002).
(3) If an EGT fluctuation/loss has been reported by the crew, do trouble shooting for the EGT indication (Ref. TASK 77-00-00-810-854) and (Ref. TASK 77-20-00-810-830).
(4) Check if the Engine Serial Number (ESN) of the engine was entered through the LRU IDENTIFICATION menu of the MCDU before the flight.
- if yes, no further action is required.
F 『 EEFF : ALL E ∞∞72-00-00∞∞∞∞∞∞∞∞∞∞Page 223
E E May 01/02 E
RE ECES
E
F 『
E C F M E
E E
E 56 E
E E
(5) Do an inspection of the engine for Foreign Object Damage (FOD or bird strike) (Ref. AMM TASK 72-00-00-200-006).
(6) Check if an EGT deterioration greater than 50 deg. C (using EGT value recorded in the take off report) is consistant with the EGT trend monitoring data (GEM or ADEPT):
- if no, do trouble shooting of the EGT system (Ref. TASK 77-00-00-810-849)
- if yes, no action is required. Further re-occurences of the same CFDS message can be expected during following flights. This is indicative that the remaining EGT margin left on this engine is equal or less than 12 deg. C.
F 『 EEFF : ALL E ∞∞72-00-00∞∞∞∞∞∞∞∞∞∞Page 224
E E May 01/02 ERE
ECES E
F 『
E C F M E
E E
E 56 E
E E
TASK 72-00-00-810-813
EGT near the HPC Operating Line Limit on Engine 2
1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
77-00-00-810-849 EGT Overlimit on Engine 1 or 2 77-00-00-810-854 Loss of the EGT Indication on Engine 1 or 2 77-20-00-810-831 The EGT indication fluctuates while other parameters
are stable AMM 72-00-00-200-006 Inspection/Check of Foreign Objet Damage (FOD) (Bird Strike Included) AMM 75-31-00-210-002 Visual Inspection of the Variable Bleed Valve System
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 發動機 ENGINE(11)
