曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  |  |  |  | target and barometer  | 
R  |  |  |  | references shown, and  | 
R  |  |  |  | correct them if necessary  | 
R  | 22  |  |  | (reset successful).  | 
R
 |  |  |  |If the fault continues, open |
 |  |  |  | again the two C/Bs 9CA1  |
 |  |  |  | on 49VU and 9CA2 on 121VU.  |
 |  |  |  |Close the C/Bs after 7 min,  |
 |  |  |  | with an interval less than  |
 |  |  |  | 5 sec between side 1 and  |
 |  |  |  | side 2.  | 
R  |  |  |  |At least 30 sec are necessary|
 |  |  |  | until the end of the FCU1  |
 |  |  |  | and FCU2 safety test.  | 
R  |  |  |  |If the fault does not  | 
R  |  |  |  | continue, do a check of the | 
R  |  |  |  | target and barometer  | 
R  |  |  |  | references shown, and  | 
R  |  |  |  | correct them if necessary  | 
R 
R  |  |  |  | (reset successful)  | 
R  |  |  |  |If the fault continues, end  | 
R  |  |  |  | of procedure (reset  | 
R  |  |  |  | unsuccessful).  |
 |  |-----------------------------------------------------------------------|
 |  |One MCDU locked or blank  |  MCDU  | Open then close the C/B of  |
 |  |Both MCDUs locked or blank |  FMGC  | the defective MCDU after 10 |

 

 |-----------------------------------------------------------------------------| | ATA | SYSTEM MALFUNCTION | COMPUTER | RESET | | | | | PROCEDURE | |-----------------------------------------------------------------------------| | | | | seconds: | | | | | - For the MCDU1: on the | | | | | panel 121VU or panel 49VU,| | | | | C/B 11CA1. | | | | | - For the MCDU2: on the | | | | | panel 121VU, C/B 11CA2. | | | | | - For the MCDU3: on the | | | | | panel 121VU, C/B 11CA3. | | |-----------------------------------------------------------------------| | |FMGC malfunction | FMGC | On the panel 121VU or 49VU: | | | | | - open the FMGC 1 C/B 10CA1 | | | | | and close it after 10 | | | | | seconds. | | | | | If there is no reset of the | | | | | FMGC 1, do a reset of the | | | | | FMGC 2 on the panel 121VU: | | | | | - open the C/B 10CA2 and | | | | | close it after 10 seconds.| |-----------------------------------------------------------------------------|
 **ON A/C 001-049, 051-099, 101-105, 201-299,
 E. Communications
 (1) Computer Reset Table
 |-----------------------------------------------------------------------------| | ATA | SYSTEM MALFUNCTION | COMPUTER | RESET | | | | | PROCEDURE | |-----------------------------------------------------------------------------| | |COM CIDS 1+2 FAULT | CIDS |- Open the C/Bs in this | | | | | order: | | | | | on the panel 49VU, C/B 150RH| | | | | on the panel 121VU, C/B | | | | | 151RH | | | | |- After 10 seconds, close | | | | | the C/Bs in this order: | | | | | 151RH, 150RH. | | |-----------------------------------------------------------------------|
 |  | Frozen RMP  |  RMP  | You must do a reset of all  |
 |  |  |  | the RMPs, one after the  |
 | 23  |  |  | other.  |
 |  |  |  | On the RMP control panel:  |
 |  |  |  | - set the ON/OFF switch to  |
 |  |  |  |  OFF  |
 |  |  |  | - after 5 seconds, set the  |
 |  |  |  |  ON/OFF switch to ON.  |

 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞24-00-00∞∞∞∞∞∞∞∞∞∞Page 236
 Aug 01/05 CES

 |-----------------------------------------------------------------------------| | ATA | SYSTEM MALFUNCTION | COMPUTER | RESET | | | | | PROCEDURE | |-----------------------------------------------------------------------------| | |-----------------------------------------------------------------------| | | Frozen FAP | Tape | On the panel 121VU, open | | | | reproducer | the FAP C/B 170RH. | | | | | - After 10 seconds, close | | | | | the C/B 170RH. | | | | | If unsuccessful: | | | | | on the panel 2000VU | | | | | - open the tape reproducer | | | | | /PRAM C/B 2RX. | | | | | After 10 seconds, close the | | | | | C/B. | |-----------------------------------------------------------------------------|
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 電源 1(88)