NlG Steering Angle Exceedance
1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 05-51-23-200-001 Inspection after NLG Steering Angle of more than 95.
3. Fault Confirmation
__________________
A. Not Applicable
4. Fault Isolation
_______________
A. After a NLG steering angle:
(1) Do the procedure: Inspection of the Nose Landing Gear after NLG Steering Angle of more than 95. (Ref. AMM TASK 05-51-23-200-001).
Runway or Taxiway Leaving
1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 05-51-24-200-001 Inspection after Leaving Runway or Taxiway
3. Fault Confirmation
__________________
A. Not Applicable
4. Fault Isolation
_______________
A. After a runway or taxiway leaving:
(1) Do the procedure: Inspection after Leaving Runway or Taxiway (Ref. AMM TASK 05-51-24-200-001).
R Flight Through Dust Storm/Volcanic Ash or Severe Conditions on Ground
1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 05-51-25-200-002 Inspection after Flight through Dust Storm or Dust Contamination on Ground AMM 05-51-25-200-003 Inspection after Flight through Volcanic Ash or Volcanic Ash Contamination on Ground
3. Fault Confirmation
__________________
A. Not Applicable
4. Fault Isolation
_______________
A. After a flight through dust storm/volcanic ash or severe conditions on ground:
(1) Do the procedure: Inspection after Flight Through Dust Storm or Dust Contamination on Ground (Ref. AMM TASK 05-51-25-200-002) or Inspection after Flight Through Volcanic Ash or Volcanish Ash Contamination on Ground (Ref. AMM TASK 05-51-25-200-003).
Engine Side Loads
1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
R AMM 05-51-27-200-001 Inspection after Impact on Engine Cowls
3. Fault Confirmation
__________________
A. Not Applicable
4. Fault Isolation
_______________
A. After an engine side loads:
(1) Do the procedure: Inspection after Engine Side Loads (Ref. AMM TASK 05-51-27-200-001).
R Fluid Spillage in Cargo Compartment
1. Possible Causes_______________
2. Job Set-up Information______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R AMM 05-51-28-200-002 Procedure after Fluid Spillage
3. Fault Confirmation__________________
A. Not Applicable
4. Fault Isolation_______________
R A. After fluid spillage in cargo compartment:
R R (1) Do the procedure: Inspection after Fluid Spillage (Ref. AMM TASK 05-51-28-200-002).
Abnormal Pax/Crew Door Movement
1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 時間限制/維護檢查(7)
