(3)
 Put the movable taxiway plates in front of the wheels to make the ground solid.

 (4)
 Connect the CABLE, TOWING - MLG (98A09001002000) or CABLE, TOWING -MLG (98A09003500000) to the tractor.

 (5)
 Install the BAR - STEERING NOSE WHEEL (98A09003000001) on the nose landing gear.

R EFF : ALL  09-10-00Page 234   Aug 01/05   CES

 Towing Attachment
 Figure 210/TASK 09-10-00-991-014

R EFF : 001-003, 051-052,  09-10-00Page 235   Aug 01/05   CES R **ON A/C 004-049, 053-099, 101-149, 151-199, 201-299, 301-399, 401-499,

 Subtask 09-10-00-480-052-A
 C. Installation of the Towing Strap and Towing Cable
 (Ref. Fig. 210A/TASK 09-10-00-991-014-A)

 WARNING : MAKE SURE THAT THE NLG DOWNLOCK SAFETY PIN AND THE TWO DOOR
_______
 SAFETY PINS ARE INSTALLED.

 (1)
 Use a towing strap with the properties that follow:

 -Length 2160 mm (85.0394 in.)
 -Width 100 mm (3.9370 in.)
 -Safe working load 13000 daN (29225.1570 lbf).

 (2)
 Wind the towing strap around the bottom of the MLG shock absorber and the axles.

 NOTE : Make sure the towing strap does not touch the links of the
____
 MLG.

 (3)
 Connect the CABLE, TOWING - MLG (98A09001002000) or CABLE, TOWING -MLG (98A09003500000) to the towing strap.

 (4)
 Put the movable taxiway plates in front of the wheels to make the ground solid.

 (5)
 Connect the CABLE, TOWING - MLG (98A09001002000) or CABLE, TOWING -MLG (98A09003500000) to the tractor.

 (6)
 Install the BAR - STEERING NOSE WHEEL (98A09003000001) on the nose landing gear.

 **ON A/C ALL
 Subtask 09-10-00-860-056
 D. Set the Lighting System and the Communication System to this
 Configuration

 (1) On the panel 25VU:
 -
set the EXT LT/NAV & LOGO switch to ON,

 -
set the EXT LT/BEACON switch to ON,

 -
set the INT LT/DOME switch to BRT.

R EFF : ALL  09-10-00Page 236   Aug 01/05   CES

 Towing Attachment Figure 210A/TASK 09-10-00-991-014-A
R EFF : 004-049, 053-099, 101-149, 151-199,  09-10-00Page 237 201-299, 301-399, 401-499, Aug 01/05   CES

 (2)
 VHF System

 -If communication is necessary between the aircraft and the control tower, on the RMP (Radio Management Panel) 11VU, push the VHF1 pushbutton switch. On the panel 60VU, connect a boomset.

 (3)
 Flight Interphone System

 -On the panel 108VU, connect a boomset to the FLT INT socket. This lets you speak to the cockpit.
 4. Procedure
_________
 Subtask 09-10-00-584-052
 A. Towing
 WARNING : MAKE SURE THAT WHEN THE AIRCRAFT MOVES WITH ITS POWER ON THE
_______
 GROUND

 -
NO PERSONS GO WHERE THE AIRCRAFT CAN CAUSE THEM INJURY OR CAN KILL THEM

 -
NO OBJECTS STAY WHERE THE ENGINES CAN BLOW THEM AWAY OR CAN PULL THEM INTO THE ENGINES BY SUCTION.

 WARNING : MAKE SURE THAT THE NLG DOWNLOCK SAFETY PIN AND THE TWO DOOR
_______
 SAFETY PINS ARE INSTALLED.

 WARNING : DURING TOWING/TAXIING OPERATIONS (LOW-SPEED OPERATIONS
_______ INCLUDED), EACH PERSON IN THE AIRCRAFT MUST BE IN A SEAT AND THE SEAT BELT MUST BE FASTENED. IF THE SEAT BELT IS NOT FASTENED, THERE IS A RISK OF INJURY IF THE AIRCRAFT STOPS SUDDENLY.
 (1)
 Tow the aircraft (Ref. TASK 09-10-00-584-001).

 (2)
 Where possible, keep the tractor aligned with the aircraft centerline. The maximum lateral position that is permitted is the width of the aircraft. (Ref. Fig. 205/TASK 09-10-00-991-004)

 NOTE : During the towing operations, put:
____ - one person in the cockpit to operate the brakes if necessary,
 -two persons to monitor the wing tips.
 EFF : ALL  09-10-00Page 238   Aug 01/05R   CES

 5. Close-up
________
 Subtask 09-10-00-210-059

 A. Visual Inspection R (1) After you have completed the towing operation make sure that the nose
R  wheels are aligned with the aircraft centerline. Subtask 09-10-00-860-057
 B. Aircraft Maintenance Configuration
 (1)
 Put the wheel chocks in position in front of and behind the wheels of the NLG and MLG.

 (2)
 On the panel 110VU:

 -set the PARKING BRK control-switch to ON.

 (3)
 On the panel 400VU:
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM TOWING & TAXIING(10)