曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

computes, the flight crew
must consider and fully understand the consequences.
CAUTION Do not pull the following circuit breakers:
‐ SFCC (could lead to SLATS/FLAPS locked).
‐ ECU or EEC, EIU.
Also refer to the Refer to FCOM/99 Duref Cible QRH
Note: In the table's "reset" column, the "if applicable" note signifies that, depending
on the computer
standard, the reset procedure may no longer be necessary. If this is the case, the reset
procedure
is removed from the applicable FCOM section.
ABN-80
27/32
AQU3I1CK8 R/AEF3E1RE9N/ACE3 H2A0ND/A B3O2OK1
ABNORMAL AND
EMERGENCY PROCEDURES 30 AUG 10
A318/A319/A320/A321 FLEET ,
COMPUTER RESET TABLE
ATA System malfunction or
ECAM Warning/Caution Affected System Reset
21
VENT AVNCS SYS FAULT AEVC On ground only:
‐ Pull C/B Y 17 on 122VU
‐ Wait 1 s before pushing the C/B.
22
AUTO FLT FCU 1(2) FAULT FCU In flight:
‐ Pull the C/B B05 on 49VU for
FCU1, or M21 on 121VU for
FCU2.
‐ Push it after 5 s.
‐ CHECK the displayed
targets and the barometer
reference, and correct them
if necessary.
On ground:
‐ Pull the C/B B05 on 49VU for
FCU1, or M21 on 121VU for
FCU2.
‐ Push it after 5 s.
‐ If FCU1(2) FAULT
disappears, CHECK the
displayed targets and
barometer reference, and
correct them if necessary
(RESET successful)
‐ If FCU1(2) FAULT remains,
pull both C/B B05 on 49VU
and M21 on 121VU
‐ Push them after 7 min, with
a delay of less than 5 s
between side 1 and 2
‐ Wait at least 30 s for FCU1
and FCU2 safety tests
completion
‐ CHECK the displayed
targets and barometer
reference, and correct
them if necessary (RESET
successful)
To be continued on next page
ABN-80
28/32
AQU3I1CK8 R/AEF3E1RE9N/ACE3 H2A0ND/A B3O2OK1
ABNORMAL AND
EMERGENCY PROCEDURES 30 AUG 10
A318/A319/A320/A321 FLEET ,
Continued from previous page
AUTO FLT FCU 1+2 FAULT FCU In flight:
‐ Pull the C/B B05 on 49VU
for FCU1, and then M21 on
121VU for FCU2.
‐ Push them after 5 s.
‐ CHECK the displayed
targets and the barometer
reference, and correct them
if necessary.
On ground:
‐ Pull the C/B B05 on 49VU
for FCU1, and then M21 on
121VU for FCU2.
‐ Push them after 5 s
‐ If FCU 1+2 FAULT
disappears, CHECK the
displayed targets and
barometer reference, and
correct them if necessary
(RESET successful)
‐ If FCU 1+2 FAULT remains,
pull again both C/B B05 on
49VU and M21 on 121VU
‐ Push them after 7 min, with
a delay of less than 5 s
between side 1 and 2
‐ Wait for at least 30 s for
FCU1 and FCU2 safety tests
completion
‐ CHECK the displayed
targets and barometer
reference, and correct
them if necessary (RESET
successful)
FCU targets are synchronized
on current aircraft values, and
displayed as selected targets.
‐ RE-ENTER the barometer
altimeter setting value, if
necessary.
AUTO FLT YAW DAMPER 1(2)
FAULT
FAC 1(2)
WINDSHEAR DET FAULT or
REAC W/S DET FAULT ��
FAC 1+2
Refer to FCOM/PRO-ABN-22-A
AUTO FLT YAW DAMPER
1(2), if applicable
One MCDU locked, or blank MCDU Refer to FCOM/99 Duref Cible
FCOM
Both MCDU locked, or blank FMGC
FMGC malfunction FMGC
23
COM CIDS 1+2 FAULT CIDS On ground, or in flight:
‐ Pull theC/Bs in the following order:
P13 �� and P14 �� on 121VU
M05 and, M06 on 121VU,
G01 and G02 on 49VU.
‐ Wait 10 s, then:
‐ Push the C/B in the following order:
G01, G02, M05, M06.
P13 �� , P14 ��
‐ After CIDS reset, wait approximately 4 min, before
recovering normal operation.
To be continued on next page
ABN-80
29/32
AQU3I1CK8 R/AEF3E1RE9N/ACE3 H2A0ND/A B3O2OK1
ABNORMAL AND
EMERGENCY PROCEDURES 30 AUG 10
A318/A319/A320/A321 FLEET ,
Continued from previous page
Uncommanded EVAC
horn activation
CIDS On ground, or in flight:
Press the EVAC HORN SHUT OFF pb. Set the EVAC
CAPT & PURS CAPT sw to the CAPT only position. Wait
for 3 s. IF UN SUCCESSFUL:
Pull the C/Bs for DIR2 ‐ in the following order: G02 on
49VU, M06 on 121VU.
IF UNSUCCESSFUL
‐ Pull the C/Bs for DIR1 in the following order: G01 on
49VU, M05 on 121VU.
‐ Wait for 1 min, then:
‐ Push the C/Bs for DIR2 in the following order: M06, G02.
‐ After CIDS reset, wait approximately 4 min, before
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：空客320快速檢查單QRH QUICK REFERENCE HAND BOOK7(6)