曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

autopilot. The AP engage annunciation will also appear in yellow whenever the FD SYNC switch
is being pressed with the autopilot engaged.
NOTE
While the FD SYNC switch is pressed, trimming the horizontal
stabilizer will not disengage the autopilot.
AP/FD Synchronization
Figure 04−10−13
FD Failure
If the active flight director fails, the flight director command bars are removed from both PFDs
and replaced by a red boxed FD annunciation. An FD 1(2) FAIL status EICAS message may also
be displayed.
If the active FD fails, selecting the XFR button on the FCP deselects the failed flight director and
allows the cross-side flight director to become active.
AUTOMATIC FLIGHT CONTROL SYSTEM
Description
Vol. 2 04−10−15
Oct 05/06
CL−605 Flight Crew Operating Manual
PSP 605−6
FLIGHT DIRECTORS (CONT'D)
Selecting the other AFCS (1 or 2) enables the second pair of FCCs, which would then allow the
autopilot to be reengaged.
FD Failure Indications
Figure 04−10−14
Flight Director Lateral Modes
There are eight flight director lateral modes (bold letters refer to the FCP button selections):
• Roll
• Heading select (HDG)
• Half bank (1/2 BANK)
• Navigation; FMS, VOR, LOC (NAV)
• Approach; FMS, VOR, LOC (APPR)
• Back course (B/C)
• Takeoff
• Go-around
Lateral modes are armed or activated by push-buttons on the flight control panel or on the thrust
levers. In general, deselecting the active lateral mode is accomplished by reselecting the active
FCP mode push-button, or by selecting another lateral mode.
Roll Mode
ROLL is the basic lateral operating mode, and is automatically selected when no other lateral
mode is active and the flight director is on. A green ROLL annunciation appears in the active
lateral field of the FMA when roll mode is active.
Roll mode generates commands to maintain a reference bank angle. If the roll attitude (bank
angle) is more than five degrees from level when roll mode is selected, the FCC generates
commands to maintain the bank angle. If the roll attitude is less than five degrees, the FCC
generates commands to maintain heading by rolling to zero bank (wings level).
AUTOMATIC FLIGHT CONTROL SYSTEM
Description
Vol. 2 04−10−16
Oct 05/06
CL−605 Flight Crew Operating Manual
PSP 605−6
FLIGHT DIRECTORS (CONT'D)
The pilot flying may adjust the roll reference to a desired roll angle by pushing the FD SYNC
button and manually setting a bank angle up to 30 degrees. If the pilot selects a bank angle
greater than 30 degrees, but less than 45 degrees, the FD will generate commands to return to
30 degrees’ bank upon release of the FD SYNC button.
Roll mode is automatically cleared by selection of another lateral mode.
NOTE
Roll mode is automatically selected if the data required to fly the
active lateral mode becomes invalid.
Roll Mode
Figure 04−10−15
Heading Select Mode
Pushing the HDG button on the FCP alternately selects and clears heading select mode. A
green HDG annunciation appears in the active lateral field of the FMA when the mode is active.
Heading select mode generates commands to capture and maintain the selected heading
(heading bug). When heading mode is selected, the direction of turn will be the shortest turn to
the heading bug. The desired heading can be changed by turning the HDG knob on the FCP.
With heading mode active, the direction of turn will always be in the direction the heading bug is
moved. The heading bug may be synchronized to the aircraft’s current heading by pressing the
PUSH SYNC button in the center of the heading knob.
Heading mode is automatically cleared by selection or capture of another lateral mode, or by
pressing the HDG button again.
AUTOMATIC FLIGHT CONTROL SYSTEM
Description
Vol. 2 04−10−17
Oct 05/06
CL−605 Flight Crew Operating Manual
PSP 605−6
FLIGHT DIRECTORS (CONT'D)
Heading Mode
Figure 04−10−16
Half Bank Mode
Pushing the 1/2 BANK button on the FCP alternately selects and clears half bank mode. When
the mode is active, a white 1/2 BNK annunciation appears to the left of the active/captured roll
mode on the PFDs, and a green arc is displayed at the top of the roll scale. Half bank mode may
be selected simultaneously with heading (HDG) or FMS navigation mode.
When active, half bank mode (1/2 BANK) reduces the roll limit to half the normal value for the
active lateral mode.
Half bank mode is cleared automatically by activation of a noncompatible lateral mode (TO, GA,
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：龐巴迪挑戰者605機組操作手冊 CL605-AUTOMATIC_FLIGHT_CONTROL_S(7)