曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

PROCEDURE COMPLETED
• IF NO ASSOCIATED DOOR MESSAGE DISPLAYED
1. Open cabin door and both nose baggage doors.
2. Secure each door making sure that all latches and the key lock as appropriate are
secured.
3. Verify CAS message clears.
PROCEDURE COMPLETED
 IF MESSAGE DOES NOT CLEAR
4. Verify all doors are properly secured.
PROCEDURE COMPLETED
 IF MESSAGE CLEARS
PROCEDURE COMPLETED
3-128 AA 510FM-07
MODEL 510 SECTION III - OPERATING PROCEDURES
ABNORMAL PROCEDURES
FAA APPROVED
Configuration U.S.
 NOSE DOOR L-R
Indicates that the latches of one or both nose baggage doors are not properly secured.
• ON GROUND
1. Correct prior to flight. Secure nose door if open, unlatched, or unlocked.
PROCEDURE COMPLETED
• IN FLIGHT
1. Land as soon as practical.
PROCEDURE COMPLETED
510FM-07 AA 3-129/3-130

MODEL 510 SECTION III - OPERATING PROCEDURES
ABNORMAL PROCEDURES
FAA APPROVED
Configuration U.S.
ADVISORY MESSAGES
White CAS messages are advisory in nature and denote items which are considered normal during
operation of the airplane or do not normally require any pilot action. These are intended primarily to
provide feedback to the pilot regarding system status. However, some procedures are provided in
the event a white message posts at an inappropriate time or when not commanded by the pilot.
Garmin G1000 System Messages are displayed in the PFD message window and are accessed by
pressing the MSG softkey on either PFD. Additional information on these and other Garmin G1000
advisory messages can be found in the Garmin G1000 Cockpit Reference Guide.
 CABIN ALT - WHITE
This message is displayed when the pressurization system is operating in High Altitude Airfield
mode and cabin altitude exceeds 10,000 feet for less than 30 minutes.
 ENG A/I COLD L-R – WHITE
Indicates that the engine inlet temperature is below safe level for satisfactory ice protection. This
message will post in white for up to two minutes after engine anti-ice is turned on while the inlet
warms up to the normal operating temperature.
 FUEL BOOST L-R - WHITE (FUEL BOOST PUMP ON)
Indicates that the respective fuel boost pump has been activated normally.
 FUEL LO INOP L-R
Indicates that the fuel quantity signal condition is not able to determine if the fuel level is below
170 lbs. in the respective tank.
1. Refer to Abnormal Procedures, FUEL QUANTITY RED ‘X’ OR INCORRECT FUEL
INDICATION if required.
PROCEDURE COMPLETED
 FUEL TRANSFER
Indicates that the fuel transfer valve is open. In the event this message remains displayed after
the fuel transfer knob is turned OFF, refer to Abnormal Procedures, FUEL TRANSFER
MESSAGE ON WHEN TRANSFER NOT SELECTED.
 MFD COLD
Indicates that the MFD temperature is below -20°C. Engine start should be delayed until this
CAS message clears. The MFD is warmed and operational when the individual display elements
such as letters and cursors change without blurring or streaking. Engines may be started when
engine instrument numerical values are legible on the MFD.
510FM-07 AJ 3-131
SECTION III - OPERATING PROCEDURES MODEL 510
ABNORMAL PROCEDURES
FAA APPROVED
U.S. Configuration
 NO TIRE SPINDOWN
Indicates that the spindown feature of the antiskid system has failed. The following procedures
are required for subsequent flights.
AFTER TAKEOFF
1. ANTISKID Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . OFF
2. Brakes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . APPLY GENTLY to stop wheel rotation
3. ANTISKID Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ON
4. LANDING GEAR Handle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . UP
PROCEDURE COMPLETED
 PRESS CTRL - WHITE
(PRESSURIZATION CONTROL BACKUP MODE)
Indicates the loss of communication between the Pressurization Controller and the Garmin
system. Pressurization system will continue to function normally using built-in backup sensors;
however, it will not be possible to change the Destination Elevation.
 PRESS OFF (PRESSURIZATION OFF)
Indicates that the AIR SOURCE SELECT Knob is in either the OFF or FRESH AIR position. The
cabin will not pressurize unless switch positioned in L, BOTH, or R.
• IF CABIN PRESSURIZATION IS DESIRED
1. AIR SOURCE SELECT Knob. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . L, BOTH, or R
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：Citation Mustang airplane flight manual 1(85)