曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

NAT MNPS 60 Edition 2009
a) checking malfunction codes for indication of unserviceability
b) obtaining a fix. It may be possible to use the following:
- the weather radar (range marks and relative bearing lines) to determine the position relative to an identifiable landmark such as an island; or
- the ADF to obtain bearings from a suitable long-range NDB, in which case magnetic variation at the position of the aircraft should be used to convert the RMI bearings to true; or
- if within range, a VOR, in which case the magnetic variation at the VOR location should be used to convert the radial to a true bearing (except when flying in the Canadian Northern Domestic Airspace where VOR bearings may be oriented with reference to true as opposed to magnetic north).
c) contacting a nearby aircraft on VHF, and comparing information on spot wind, or ground speed and drift.
d) if such assistance is not available, and as a last resort, the flight plan wind speed and direction for the current DR position of the aircraft, can be compared with that from navigation system outputs.
Action if the Faulty System Cannot be Identified
10.1.7 Occasions may still arise when distance or cross track differences develop between systems, but the crew cannot determine which system is at fault. The majority of operators feel that the procedure most likely to limit gross tracking errors under such circumstances is to fly the aircraft half way between the cross track differences as long as the uncertainty exists. In such instances, ATC should be advised that the flight is experiencing navigation difficulties so that appropriate separation can be effected if necessary.
Guidance on What Constitutes a Failed System
10.1.8 Operations or navigation manuals should include guidelines on how to decide when a navigation system should be considered to have failed, e.g. failures may be indicated by a red warning light, or by self diagnosis indications, or by an error over a known position exceeding the value agreed between an operator and its certifying authority. As a generalisation, if there is a difference greater than 15 NM between two aircraft navigation systems (or between the three systems if it is not possible to detect which are the most reliable) it is advisable to split the difference between the readings when determining the aircraft's position. However, if the disparity exceeds 25 NM one or more of the navigation systems should be regarded as having failed, in which case ATC should be notified.
Inertial System Failures
10.1.9 INSs have proved to be highly accurate and very reliable in service. Manufacturers claim a drift rate of less than 2 NM per hour; however in practice IRSs with laser gyros are proving to be capable of maintaining accuracy to better than 1NM per hour. This in itself can lead to complacency, although failures do still occur. Close monitoring of divergence of output between individual systems is essential if errors are to be avoided and faulty units identified.
GPS Failures
10.1.10 If the GPS displays a “loss of navigation function alert”, the pilot should immediately revert to other available means of navigation, including DR procedures if necessary, until GPS navigation is regained. The pilot must report the degraded navigation capability to ATC.
NORTH ATLANTIC MNPSA OPERATIONS MANUAL CHAPTER 10
NAT MNPS 61 Edition 2009
Satellite Fault Detection Outage
10.1.11 If the GPS receiver displays an indication of a fault detection function outage (i.e. RAIM is not available), navigation integrity must be provided by comparing the GPS position with the position indicated by another LRNS sensor (i.e. other than GPS), if the aircraft is so equipped. However, if the only sensor for the approved LRNS is GPS, then comparison should be made with a position computed by extrapolating the last verified position with airspeed, heading and estimated winds. If the positions do not agree within 10 NM, the pilot should adopt navigation system failure procedures as subsequently described, until the exclusion function or navigation integrity is regained, and should report degraded navigation capability to ATC.
Fault Detection Alert
10.1.12 If the GPS receiver displays a fault detection alert (i.e. a failed satellite), the pilot may choose to continue to operate using the GPS-generated position if the current estimate of position uncertainty displayed on the GPS from the FDE algorithm is actively monitored. If this exceeds 10 nm, the pilot should immediately begin using the following navigation system failure procedures, until the exclusion function or navigation integrity is regained, and should report degraded navigation capability to ATC.
10.2 LOSS OF NAVIGATION/FMS CAPABILITY
10.2.1 Some aircraft carry triplex equipment (3 LRNSs) and hence if one system fails, even before take off, the two basic requirements for MNPS Airspace operations may still be met and the flight can proceed normally. The following guidance is offered for aircraft having state approval for unrestricted operations in MNPS airspace and which are equipped with only two operational LRNSs:
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：NORTH ATLANTIC MNPS AIRSPACE OPERATIONS MANUAL(47)