曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

(e)  all open connections should be blanked; and 
 
(f)  a protected and enclosed quarantine storage area for the parts being removed should be provided in the immediate vicinity of the work area and 
(g)  normal maintenance documentary controls should be used, e.g. the use of work sheets or cards to record component removals, and label identification to show serviceability status. 
 
An assessment for condition and eventual return to service of each removed part will need to be conducted by a suitably approved organization. The extent of the work necessary before the part is returned to service may, depending on various factors, range from a simple external visual inspection to a complete overhaul. 
 
5.3  Parts Recovered From Aircraft Involved In Accidents 
 
When an aircraft has been involved in an accident, the title to the salvage may pass from the insured owner to other persons (e.g. aircraft insurers); this salvage may be offered for sale either complete or as separate aircraft items in an “as is, where is” condition. While some items may be totally unaffected by the accident or incident which caused the aircraft to be declared as salvage, it is essential to obtain clear evidence that this is the case. If such evidence cannot be obtained, the item may not be returned to service. 
 
Before overhaul and reinstallation can be considered, all such items must therefore be subject to airworthiness assessment and inspection in the light of adequate knowledge of the circumstances of the accident, subsequent storage and transport conditions, and with evidence of previous operational history obtained from valid airworthiness records. Confirmation of this assessment in the form of an airworthiness release is essential. 
 
In particular, if a crash load is sufficient to take any part above its proof strength, residual strains may remain which could reduce the effective strength of the item or otherwise impair its functions. Loads higher than this may of course crack the item, with an even more dangerous potential. Further, a reduction in strength may be caused by virtue of the change of a material’s characteristics following overheat from a fire. It is therefore of the utmost importance to establish that the item is neither cracked, distorted or overheated. The degree of distortion may be difficult to assess if the precise original dimensions are not known, in which case there is no option but to reject the item. Any suggestion of overheating would be cause for a laboratory investigation into significant change of material properties. 
 
6.   DISPOSAL OF SCRAPPED PARTS 
 
Those responsible for the disposal of scrapped aircraft parts and materials should consider the possibility of such parts and materials being misrepresented and sold as serviceable at a later date. Caution should be exercised to ensure that the following types of parts and materials are disposed of in a controlled manner that does not allow them to be returned to service: 
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CIVIL AVIATION PUBLICATIONS CAP 31 AIRCRAFT PARTS AUTHENTICITY(8)