曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

The throughput subparameter shall be defined as one of the
values (unspecified, 75, 150, 300, 600, 1 200, 2 400, 4 800,
9 600, 19 200, 48 000, 64 000 bitsls).
4.7.3.15.6 TRANSITDELAY
4.7.3.15.6.1 The negotiated transit delay shall apply to
both directions of transfer.
Annex 10 - Aeronautical Telecommunicah~ons Volume III
4.7.3.15.6.2 Aircrafi-originated connection
establishment
4.7.3.15.6.2.1 The SSNDPA shall map directly the
lransit delay selection and indication (TDSAI) facility in the
call request packet to the same facility in the connection
request SNPDU.
4.7.3.15.6.2.2 If the SSNDPG receives a call accepted
packet from the IWF in response to an incoming call. packet
with TDSAI facility, it shall forward the same facility in the
connection confirm SNPDU to the SSNDPA.
4.7.3.15.6.3 Ground-originated
connection establish men^
If the SSNDPG receives a call request packet with the TDSAI
facility from the IWF, the SSNDPG shall forward to the
SSNDPA a mean value for the satellite subnetwork transit
delay of a data SNPDU of 13 1 octets in the connection request
SNPDU.
4.7.3.15.7 FASTSE LECT
The fast select facility shall be treated as follows:
a) a call request packet without the fast select facility
shall be mapped to a connection request with no restriction
on response SNPDU with the fast select (use not
permitted) facility; -
b) a call request packet with the fast select facility
indicating fast select requested with no restriction on
response shall be mapped to a connection request with
no restriction on response SNPDU without the fast
select (use not permitted) facility; and
c) a call request packet with the fast select facility
indicating fast select request with restriction on
response shall be mapped to a connection request with
restriction on response SNPDU without the fast select
(use not permitted) facility.
4.7.3.15.8 EXPEDITEDDA TA NEGOTIATION
The expedited data negotiation facility in the call request or
call accepted packet shall not be mapped to the corresponding
connection request or connection confirm SNPDU unless the
facility parameter is set to "no use of expedited data".
4.7.3.15.9.2 If the SSNDPX has initiated the clear or
reset procedure, then the clearing cause, the resetting cause
and the diagnostic code fields shall be set as defined in Tables
4-16 and 4-17.
4.7.3.15.1 0.1 If the user data field in the data packets of
an M-bit packet sequence is less than the default data ShTDU
maximum user data field length, then these fields shall be
concatenated to fom an M-bit SNPDU sequence.
4.7.3.15.10.2 If the user data field in the data packets of
an M-bit packet sequence is greater than the default data
SNPDU maximum user data field length, then these fields
shall be segmented to form an M-bit SNPDU sequence.
4.7.3.16 SNmU TO PACKET
MAPPLNG RULES
4.7.3.16.1 This section shall specify the rules for
mapping the SNPDU fields into the corresponding fields in
IS0 8208 packet.
4.7.3.16.2 DTE ADDRESS
4.7.3.16.2.1 The called DTE address and the calling
'DIE address fields in the connection request SNPDU shall be
directly mapped into the called DTE address and the calling
DTE address fields in the incoming call packet.
4.7.3.16.2.2 Both the calling and called DTE address fields
shall be regenerated when forwarding a call connected packet,
if they were present in the corresponding call request packet.
4.7.3.1 6.3 NSAP ADDRESS
4.7:3.16.3.1 The called NSAP address and the calling
NSAP address fields in the connection request SNPDU shall
be directly mapped into the called address extension and
calling address extension parameter fields in the incoming call
packet.
4.7.3.16.3.2 The called NSAP address field in the
connection confirm or connection released SNPDU shall be
mapped into the called address extension field in the call
connected or clear indication packet.
4.7.3.15.9.1 Clearing cause, resetting cause and diagnostic
code fields shall be transferred without modification
from the packets to the corresponding SNPDUs.
The Q number associated with the connection request and
connection confirm SNPDUs shall be mapped into the target
Part I Annex 10 - Aeronautical Telecommunications
and selected values of the priority of data on a connection
field in the priority facility in the IS0 8208 incoming call and
call connected packets.
4.7.3.16.5.1 The throughput class negotiation shall apply
independently for each direction of transfer.
4.7.3.16.52 Throughput
The throughput sub-parameter shall be defined as one of the
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：附件10--航空電信an10_v3_1ed(40)