曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

-c - 0.4, Vi : 0.7, maximum upward elevator deflection equals 15 deg, and
CL.max - 1.2. For stick-fixed neutral point at 0.35 mac, plot the elevator deflection
vs lift coefficient for various center of gravity locations on either side of the neutral
point.
3.15     For the aircraft in Exercise 3.7, whaL is the permissible most forward center
of gravity location in terms of mac? [Answer: -0.0164.]
3.16  An aircraft with a static margin of 0.15 has the following data: wing
loading = 1800 N/m2,aw  = 0.08/deg, at  - 0.06]deg, Cmac.w -  - 0.04,  CmaCJ
= 0, Vl - 0.55, CtoL.w - O,dCL.,/d;Se - 0.025ldeg,6 = 0.36, 77t = 0.95, St = 4 m2,
Ce -0.5 m, iw - O, /r = 3deg, Gi  -  1.6 rad/m, Cm. f =0.05 + O.lC/, Cha  =
-0.002/deg, Ch8e = ~0.005/deg, and Ch8,  = -0.006ldeg. Assuming level flight
at sea level conditions, determine (a) speed for stick force U:im at zero tab deflec-
tion and (b) tab deflection for stick force trim at a speed of 100 m/s. [Answer:
(a) 65.1322 m/s and (b) -4.0209 deg.]
3.17   For the aircraft of Exercise 3.16, determine the stick force gradients for
cases 1 and 2. [Answer: 30.09 Ns/m and 19.6 Ns/m.]
3.18   A trainer aircraft has a wing loading of 1850 N/m2 and a static margin of
0.15 while fiying at 8 deg angle of attack at an altitude of 8000 m (cr - 0.4292).
(a) To what altitude should the pilot climb the aircraft so that, at the bottom of a
 1.5 g pull-out, he is once again at 8000 m altitude?
   For this aircraft, determine (b) the elevator required per g and (c) stick force
per g based on  the following data:  e  -.  0.35ct, aw - O.lldeg, ar = 0.092ldeg,
c-2.5 m, St/S=0.3, lr=2.5 c, r7t-0.9, r  -  0.35, Cha-  - 0.003/deg,
316          PERFORMANCE, STABILITY, DYNAMICS, AND CONTROL
Chb -  - 0.006/deg, Se - 1.85 m2, Ce =0.61  m, and Gi - 1.2 rad/m. [Answer:
(a) 9793.4 m, (b) -7.3597 degtg, and (c) -73.4937 N/g.]
 3.19   An aircraft weighs 66,825 N and has a wing area of46 m2 and a taillength
 of 10.64 m. The center of gravity and wing aerodynamic centers in ternris of mean
aerodynamic chord.are, respectively, at 0.35 and 0.26 from the leading edge of
mac. The lift-curve slope of wing and that of horizontal tail are 0.09/deg and
 0.07/deg, respectively. The tail volume ratio is 0.6. Assuming Cm f  = O-lCL, € ;
0.3cc, r7, - 0.9, r = 0.5, Chu = -0.003/deg, Ch8 = -0.006/deg, Se = 1.9 IT12,
Ce  - 0.55 m, and G }  =  1.2 ratVm, determine (a) the stick-fixed maneuver margin
and (b) the increment.al elevator'setting for a coordinated tum with 30 deg bank
at an altitude of 2200 m (u : 0.8). (c) What is the stick force per g? IAnswer:
(a) 0.2402, (b) -0.3932 deg, and (c) 69.0167 N/gJ
3.20   For the airplane configuration shown in Fig. P3.20, the fuselage side area
is 40.5 m2, the maximum fuselage width is 2.5 m, and the ratio of rudder chord
to vertical tail chord is 0.30. The rudder extends from 1.56 to 3.78 m from the
fuselage centerline as shown. Assume that the wing, horizontal tail, and vertical
tail h"a"~Ue NACA 65A006 airfoil section. Determine the following:
    (a) The static directional stability parameter (Cnp)rix at M = 0.3 and an altitude
of 3000 m and at M  - 2.0 and an altitude of 15,000 m.
      (b) The rudder effectiveness Cnbr at low subsonic speeds.
    (c) The rudderlunge-moment coefficients Chp and Chlr atlow subsonic speeds,
assuming that the hingeline coincides with the leading edge of the rudder.
    (d) The rudder-free directional stability parameter (CnpX    at M =0.3.
STATIC STABILITY AND CONTROL
* NACA 65A006 Airtoil.or Wing,
  Horizontal & Vertical Tails.
' S8.S = 40-5 mz
~ bt.,ai= 2-Sm, cy : 0-3Cv.
' yi    = 1*56m, yo : 3--l8m
                                                                                     
                                                                                     
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：動力機械和機身手冊2(60)