曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

approach procedure and proceed to the destination
airport by visual reference to the surface. This
approach will only be authorized when requested by
the pilot and the reported ground visibility at the
destination airport is at least 1 statute mile.
(Refer to AIM.)
CONTAMINATED RUNWAY- A runway is
considered contaminated whenever standing water,
ice, snow, slush, frost in any form, heavy rubber, or
other substances are present. A runway is contaminated
with respect to rubber deposits or other
friction‐degrading substances when the average
friction value for any 500‐foot segment of the runway
within the ALD fails below the recommended
minimum friction level and the average friction value
in the adjacent 500‐foot segments falls below the
maintenance planning friction level.
CONTERMINOUS U.S.- The 48 adjoining States
and the District of Columbia.
Pilot/Controller Glossary 2/14/08
PCG C-6
CONTINENTAL UNITED STATES- The 49 States
located on the continent of North America and the
District of Columbia.
CONTINUE- When used as a control instruction
should be followed by another word or words
clarifying what is expected of the pilot. Example:
“continue taxi,” “continue descent,” “continue
inbound,” etc.
CONTROL AREA [ICAO]- A controlled airspace
extending upwards from a specified limit above the
earth.
CONTROL SECTOR- An airspace area of defined
horizontal and vertical dimensions for which a
controller or group of controllers has air traffic
control responsibility, normally within an air route
traffic control center or an approach control facility.
Sectors are established based on predominant traffic
flows, altitude strata, and controller workload.
Pilot‐communications during operations within a
sector are normally maintained on discrete frequencies
assigned to the sector.
(See DISCRETE FREQUENCY.)
CONTROL SLASH- A radar beacon slash representing
the actual position of the associated aircraft.
Normally, the control slash is the one closest to the
interrogating radar beacon site. When ARTCC radar
is operating in narrowband (digitized) mode, the
control slash is converted to a target symbol.
CONTROLLED AIRSPACE- An airspace of
defined dimensions within which air traffic control
service is provided to IFR flights and to VFR flights
in accordance with the airspace classification.
a. Controlled airspace is a generic term that covers
Class A, Class B, Class C, Class D, and Class E
airspace.
b. Controlled airspace is also that airspace within
which all aircraft operators are subject to certain pilot
qualifications, operating rules, and equipment
requirements in 14 CFR Part 91 (for specific
operating requirements, please refer to 14 CFR
Part 91). For IFR operations in any class of controlled
airspace, a pilot must file an IFR flight plan and
receive an appropriate ATC clearance. Each Class B,
Class C, and Class D airspace area designated for an
airport contains at least one primary airport around
which the airspace is designated (for specific
designations and descriptions of the airspace classes,
please refer to 14 CFR Part 71).
c. Controlled airspace in the United States is
designated as follows:
1. CLASS A- Generally, that airspace from
18,000 feet MSL up to and including FL 600,
including the airspace overlying the waters within 12
nautical miles of the coast of the 48 contiguous States
and Alaska. Unless otherwise authorized, all persons
must operate their aircraft under IFR.
2. CLASS B- Generally, that airspace from the
surface to 10,000 feet MSL surrounding the nation's
busiest airports in terms of airport operations or
passenger enplanements. The configuration of each
Class B airspace area is individually tailored and
consists of a surface area and two or more layers
(some Class B airspaces areas resemble upside‐down
wedding cakes), and is designed to contain all
published instrument procedures once an aircraft
enters the airspace. An ATC clearance is required for
all aircraft to operate in the area, and all aircraft that
are so cleared receive separation services within the
airspace. The cloud clearance requirement for VFR
operations is “clear of clouds.”
3. CLASS C- Generally, that airspace from the
surface to 4,000 feet above the airport elevation
(charted in MSL) surrounding those airports that
have an operational control tower, are serviced by a
radar approach control, and that have a certain
number of IFR operations or passenger enplanements.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：航空信息手冊附錄(24)